Appliances
Genie Aladdin Connect
Wall mount garage door opener WiFi reset
- Remove bottom cover (one black 1/4" hex-head screw)
- Disconnect battery
- Unplug power cord (wait 20 seconds)
- Unplug light (wait 20 seconds)
- Plug in opener (wait until WiFi light is RED)
- Plug in light (wait 2 seconds until it flashes once)
- Press and hold WiFi button until it beeps (about 5 seconds)
- Wait for WiFi light to become solid BLUE
- Turn off Cellular Data on iPhone
- Open the Aladdin app on the phone
- Press the round/gray/slashed WiFi button on the app next
- Scroll down past "Door History" and go to "Setup"
- Follow the instructions to reconnect the door opener to WiFi
- Press the Genie wall button near the house door to open door
- Wait a few minutes until the door comes back "Online"
- If it fails, call 866-599-4995 (choose Aladdin Connect Support)
- Reconnect battery
- Replace bottom cover
- Turn on Cellular Data on your phone
Automobiles
Lexus ES350 (2007)
Reset maintenance light after service
- Press START button twice (don't put foot on the brake, don't start engine)
- Press Trip/Reset button until odometer is TRIP A mode
- Press START button once to turn off car
- Press and HOLD Trip Reset button
- Press START button twice (don't put foot on the brake, don't start engine)
- Keep holding button until the 5 dashes disappear
- Press START button once to turn off car
- Check YouTube.com if necessary
Lexus RX350 (2009)
Reset maintenance light after service
- Insert key and turn to On (don't start)
- Press ODO/TRIP button to set Odometer to ODO
- Turn the engine switch off
- Press and hold Trip/Odometer button
- Turn the engine switch to the ON position (while holding down the button)
- Continue holding button until odometer displays 000000
Toyota FJ Cruiser (2010)
Reset maintenance light after service
- Insert key and turn to On (don't start)
- Press Trip/Odometer button to set to ODO
- Turn the engine switch off
- Press and hold Trip/Odometer button
- Turn the engine switch to the ON position (while holding down the button)
- Continue holding button until odometer displays 000000
Networks
Apple Airport Express
Reset to Factory Default Settings
- disconnect power
- press reset switch (tiny tiniest hole)
- reconnect power
- hold reset for 6 seconds
- wait 60 seconds to reboot
- iPhone → Settings → WiFi
- iPhone → AirPort Utility app
Cisco Linksys E1200 router
Reset to Factory Default Settings
- connect power
- press and hold reset button for 10 seconds
- router will restart automatically
Cisco RV180 router
Reset to Factory Default Settings
- connect power
- press and hold reset button for 10 seconds
- router will SLOWLY restart automatically
- browse to: http://192.168.1.1
- default login → cisco + cisco
SonicWALL TZ400
Reset to Factory Default Settings
- Paperclip reset hole (back near power indicator lights)
- Push and hold the reset button for 10 seconds
- Connect PC to SonicWALL with network cable
- Set computer's IP address
- IP: 192.168.168.20
- SM:255.255.255.0
- GW:192.168.168.168
- Navigate to http://192.168.168.168 in browser
- Click the boot icon by "Current Firmware with Factory Default Settings" to restore the SonicWALL to its original configuration.
Ubiquiti EdgeRouter X
Reset to Factory Default Settings
- Connect power
- Press and hold reset button for 20 seconds
- Wait 1 minute for router to restart
- Set laptop NIC Static IP: 192.168.1.7
- Plug laptop into eth0 port
- Browse to 192.168.1.1 → ubnt / ubnt
- Do setup wizard
- Set LAN IP to 192.168.x.1 as needed
- Turn on/off DHCP as needed
- Reboot
- Wait 1 minute for router to restart
- Plug laptop into eth1
- Plug Internet into eth0
- Set Laptop NIC to DHCP
- Renew IP address
- Browse to router's new IP address 192.168.x.1